Insulation

Buildings and Cities

Insulation

Insulation keeps the heat you paid for inside in winter and outside in summer, so every heater, air conditioner, and heat pump in the building can do less work. It is the least glamorous climate solution in the house and often the one that makes all the others cheaper and smaller.

🌱Seasons

The effect compounds within years. Put it in place and it keeps working.

Origins

People have always insulated. Sod roofs, thick adobe and stone walls, straw packed into timber frames, and wool hangings on cold walls were all ways of slowing the movement of heat long before anyone measured it. Traditional builders in cold and hot climates alike learned by experience which materials kept a home livable through the worst months.

Industrial insulation arrived in the late nineteenth century, when manufacturers found they could spin molten slag from iron furnaces into a fluffy mineral wool. Glass fiber insulation followed in the 1930s and became the familiar pink batt in American attics. Cellulose, made largely from recycled paper treated against fire, offered another option built from waste.

The modern push came from crisis. The oil shocks of the 1970s made heating costs painful almost overnight, and governments responded with building energy codes and programs to weatherize older homes, including the United States Weatherization Assistance Program, which has now been running for about half a century. Insulation shifted from a comfort upgrade to public policy.

What it actually is

Heat always flows from warm to cold. In winter it leaks out through walls, roofs, floors, and windows; in summer it pours in. Insulation does not create warmth or coolness. It simply slows that flow, so the temperature you set stays put with less help from equipment.

Most insulation works by trapping still air or gas in tiny pockets, because still air is a poor conductor of heat. Fiberglass, mineral wool, cellulose, cotton, wood fiber, sheep's wool, and foam boards all use some version of that trick. Their resistance to heat flow is measured as an R-value: the higher the number, the better it slows heat. Building codes set minimum R-values by climate zone, and older homes often fall far below them.

Insulation is only half the job. Air sealing, closing the gaps around chimneys, plumbing, attic hatches, and wall outlets, keeps warm air from simply escaping through the cracks. Insulation without air sealing is like wearing a wool sweater in the wind: it helps, but not nearly enough. The two are almost always done together.

Materials carry their own climate footprint. Some spray foams and foam boards have historically used blowing agents that are potent greenhouse gases, which can erase years of energy savings. Mineral wool, cellulose, and plant based materials generally carry much lower embodied carbon, and some bio based products even store carbon. Choosing the material is part of the climate decision.

The places that matter most are usually the attic or roof, rim joists and basements, and walls in older homes that were built with little or nothing in their cavities. An energy audit with a blower door test shows where a particular house is losing the most.

The numbers

Typical savings. ENERGY STAR estimates that sealing air leaks and adding insulation can save homeowners an average of about 15 percent on heating and cooling costs.

A national gap. A study commissioned by the North American Insulation Manufacturers Association with Boston University researchers estimated that roughly 90 percent of single family homes in the United States are under insulated.

Europe's old stock. The European Commission estimates that about 75 percent of the European Union's building stock is energy inefficient, and much of it will still be standing in 2050.

The cost of waiting. In the United Kingdom, a 2025 think tank analysis found that slow progress on insulating homes had added roughly 3.2 billion pounds to household energy bills.

A long running program. The US Weatherization Assistance Program, launched in the 1970s, has insulated and sealed millions of low income homes and remains one of the longest running energy efficiency programs in the country.

Why it matters

The cleanest unit of energy is the one you never need. Insulation cuts demand at its source, and that reduction keeps paying out for the life of the building, often fifty years or more, with no moving parts, no fuel, and almost no maintenance.

It also makes every other building solution work better. A well insulated house needs a smaller heat pump, a smaller solar array, and less grid capacity on the coldest morning of the year. That matters for the whole energy transition, because the hardest hours for an electrified grid are winter peaks, and insulation shaves them directly.

In proportion, insulation is a steady, compounding solution rather than a dramatic one. On its own it does not eliminate fossil heating. Its real role is to shrink the problem so that clean heating is affordable, and to protect people in the meantime.

That protection is the human heart of it. Cold, drafty homes are linked to respiratory illness and strain on older people, and Ireland's Warmth and Wellbeing pilot found clear physical and mental health benefits after home energy upgrades. As heat waves grow, well insulated and shaded homes also stay cooler longer, which can matter more than any thermostat for people without air conditioning.

What it actually takes

Start with an energy audit. A blower door test and thermal imaging show where a house leaks most, so money goes to the attic or rim joist that matters rather than the wall that does not.

Seal before you insulate. Close air leaks in the attic floor, basement, and around penetrations first; then add insulation so it is not fighting a constant draft.

Pick materials with low embodied carbon. Favor cellulose, mineral wool, wood fiber, or foams made with low impact blowing agents, especially for large areas.

Manage moisture and ventilation. Tighter homes need planned fresh air and attention to vapor control, so insulation does not trap moisture in walls or worsen indoor air quality.

Use replacement moments. Re-roofing, re-siding, or gutting a room is the cheapest time to add insulation, because the expensive part, opening the building, is already happening.

Where it matters most

Insulation pays off most where old buildings meet long winters or fierce summers. On the English Midlands, rows of older brick terraces with solid walls lose heat quickly, and slow progress on insulation has left many households paying for warmth that drifts straight outdoors. Along the Irish Coast and Countryside, damp, windy winters and an older rural housing stock make insulation as much a health measure as a climate one, a lesson Ireland's own programs have documented.

Across the Great Lakes Northwoods and the New England Coast, many homes were built long before modern energy codes, often with empty wall cavities and thin attic insulation, and heating seasons stretch for half the year. Every inch of attic insulation there translates into fewer gallons of oil or therms of gas burned.

In the Sonoran Desert, the logic runs in reverse. Insulation and reflective roofs keep extreme heat out, which lowers air conditioning loads during the hours when the grid is most strained and protects residents during dangerous heat waves.

How to tell it’s being done well

Was there a test before and after? Good projects measure air leakage with a blower door before work starts and again when it finishes, so the improvement is real rather than assumed.

Were the air leaks sealed first? If insulation was blown over an unsealed attic floor, much of the benefit is lost. Ask what was sealed and where.

Is the home comfortable without moisture problems? A well done job feels less drafty, holds temperature evenly, and does not lead to condensation, mold, or stuffy air. Mechanical ventilation should be part of the plan in tight homes.

What is the insulation made of? Ask about the material's embodied carbon and blowing agents. A climate project should not lean on products with high warming impact when good alternatives exist.

Who is getting it? At a program level, success means drafty rentals and low income homes are reached, not just owners who could have paid on their own. Those households save the most as a share of their budget.

What you can do

Anyone

  • Look in your attic or ask your landlord what is up there; if you can see the tops of the floor joists, there is almost certainly room for more insulation.
  • Ask your utility about free or low cost home energy audits, which often include basic air sealing on the spot.

Homeowners and renters

  • Homeowners can prioritize attic air sealing and insulation, usually the best payback in the house, before replacing windows or equipment.
  • Renters can use weatherstripping, door sweeps, and window film, and ask landlords to apply for weatherization programs aimed at rental properties.

Policymakers

  • Fund weatherization programs generously and let them fix the roof leaks, wiring, and moisture problems that often stop old homes from qualifying.
  • Require energy disclosure at sale or rental so buyers and tenants can see how leaky a home is before they sign.

Builders and contractors

  • Specify low embodied carbon insulation as the default and document blowing agents on bids.
  • Train crews in air sealing and building science, since a well installed modest insulation job often beats a poorly installed expensive one.

Who is working on this

We are researching which organizations in our directory of 8,493 actively work on this solution, and we only list an organization once we have verified it. That research is ongoing. In the meantime, search the directory yourself:

Search the directory for “Insulation” →

Questions

Is insulation really a climate solution or just a way to save money?

Both. Less heat lost means less fuel burned or electricity used, which cuts emissions for as long as the building stands. It also makes clean heating systems smaller and cheaper to run.

Where should I insulate first?

In most homes the attic or roof comes first, followed by air sealing the basement and rim joists. An energy audit will confirm the priorities for your specific house.

Can a house be too tight?

A tight house is good as long as it is ventilated on purpose. Modern practice pairs air sealing with mechanical ventilation so moisture and indoor pollutants are removed while heat stays in.

Is spray foam bad for the climate?

Some spray foams have used blowing agents that are powerful greenhouse gases, which can offset years of energy savings. Newer formulations use lower impact agents, and materials like cellulose or mineral wool are often lower carbon choices.

Does insulation help in hot climates?

Yes. It slows heat coming into the home, which lowers air conditioning use and keeps indoor temperatures safer during heat waves, especially when paired with reflective roofing and shading.

Sources

The solution taxonomy follows the framework popularised by Project Drawdown. The analysis above is our own; for their carbon modeling and rankings, visit them directly.